You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This commit was created on GitHub.com and signed with GitHub’s verified signature.
Added
Experimental Raspberry Pi 5 support (kernel_2712.img, built with BOARD=pi5-64). Audio goes to an I²S DAC; output_device = pwm falls back to I²S because the Pi 5 has no headphone jack. HDMI audio is a known issue: it only works in an HDMI_CONSOLE=1 build, and then sounds distorted. USB MIDI input works. Serial MIDI uses GPIO 14/15 as on other boards. The Active Cooler or case fan switches on at 60 °C and off below 50 °C. Use a 5 V / 5 A (27 W) or USB-C PD supply: weaker supplies can crash the Pi 5 under Wi-Fi load. Pi 500 and CM5 are untested.
Changed
SoundFont mode: switching SoundFonts while a song plays keeps each channel's instrument, bank, volume, pan, expression, reverb and chorus sends, pitch bend and bend range, so the song carries on with the same instruments in the new SoundFont. Before, every channel fell back to its default sound until the song sent new program changes.
Fixed
SoundFont mode: switching SoundFonts could crash or hang the synth, because the audio core and incoming RTP/UDP MIDI used the synth while the new SoundFont was loading into it. Now the old synth is set aside, the new one loads on its own and takes over when ready; MIDI arriving during the load is ignored. Seen on a Raspberry Pi 5; possible on every board since 0.16.1.