Skip to content

Releases

PTL-RAIL rev A v1.0

Choose a tag to compare

PTL-RAIL rev A: modular IR TX/RX rail, 400 × 40 mm, 2-layer, 5 nodes on an 84 mm pitch, ESP32-S3-WROOM-1, CAN, 24 V input.

What this release covers

  • 3D-printed shroud outlines and M3 shroud holes on every IR LED and TSOP.
  • Node passives and MOSFETs on the bottom side.
  • Test points TP5–TP19.
  • SW4 user button on IO14.
  • GND via fence, mid-board mounting holes and rounded corners.
  • Capacitor values normalised, so the BOM has 38 lines.

Checks: ERC 0 errors; DRC 0 violations, 0 unconnected.

Panel: 2-up, 400 × 127 mm. Board 2 is rotated 180° so both ESP32 antennas sit over the 20 mm rails. Boards are joined by mouse-bite tabs.

Known rev A issues (details in the root README):

  1. No 24 V input protection (fuse, reverse polarity, TVS, bulk capacitor).
  2. CAN_L sits next to VIN on J3/J4/J5/J6, and the SN65HVD230 is only rated +16 V.
  3. J3/J4 pin order is reversed. Check the harness.
  4. The J4 → IO4–IO8 inputs have no protection.
  5. The WS2812B data line is driven at 3.3 V while the LEDs run on 5 V.
  6. Capacitor voltage ratings and MPNs are not set (C1/C3 need ≥ 50 V).
  7. U3 overlaps the node-3 emitter shroud and hole H19.
  8. The 0.2 mm U3 thermal-pad holes are below the 0.3 mm design minimum. Confirm your fab can make them.