Repository navigation
Releases
Scopewerk 1.0.0
The Hanmatek DOS1102 oscilloscope on your desktop: a native app for macOS and Windows, a two-channel logic analyzer, a command line tool and an MCP server for AI agents. Pure Rust over USB, no Python, no VISA, no vendor software.
Highlights
- Live scope screen with afterglow, square divisions like the instrument, ground and trigger markers, hover readout, A/B cursors and automatic measurements.
- Every control: timebase, position, V/div, offset, coupling, probe, invert, trigger, acquisition, run/stop/single/autoset, all on the keyboard too.
- Logic analyzer on the 10 000-sample memory: CAN 2.0A/B (CRC, stuffing and ACK checked, bitrate and polarity detected, single wire or CH1−CH2), I²C, SPI and UART (auto baud), with a protocol lane and an event table.
- MCP server (
scopewerk mcp) with ten tools for Claude, Codex and other agents. While the app is open, agents work through it and you watch every change live. - Verified changes: every setting is read back from the scope, snapped to its 1-2-5 steps and reported.
- CLI with
--jsoneverywhere: status, capture, set, single, watch, decode, screenshot, raw SCPI. - Demo mode without a scope:
SCOPEWERK_DEMO=can,i2coruart.
Downloads
| macOS 11+ (Apple Silicon + Intel) | Scopewerk-1.0.0-macos-universal.dmg, CLI only: scopewerk-cli-1.0.0-macos-universal.tar.gz |
| Windows 10/11 x64 | Scopewerk-1.0.0-windows-x64.zip (app + cli\scopewerk.exe), CLI only: scopewerk-cli-1.0.0-windows-x64.zip |
macOS: ad-hoc signed, not notarized. Right-click the app → Open the first time.
Windows: not code-signed (SmartScreen: More info → Run anyway). The scope needs the WinUSB driver once, installed with Zadig: pick Oscilloscope (5345 1235) → WinUSB. The Windows build is new in this release: it is checked on Windows 11 (app, CLI, decoders, the app-to-CLI broker, in demo mode), but not yet with a scope attached over WinUSB, so reports are welcome.
Tested with the DOS1102 on firmware V1.5.0 (USB 5345:1235). The decoders are tested against synthesized bus signals (real CAN encoder with CRC and bit stuffing, RC edges, noise, 8-bit quantization); please report buses that do not decode.
