When editing Device, removing Rack attribute does not remove Rack Face attribute

[postilion]

NetBox Edition

NetBox Community

NetBox Version

v4.4.1

Python Version

3.12

Steps to Reproduce

1. from existing Device, click on Edit
2. in Edit dialogue, click the (x) on right side of Rack field to remove attribute value
3. Position attribute is cleared, but Rack Face attribute remains set
4. Click Save and get error "Cannot select a rack face without assigning a rack."

Expected Behavior

Rack Face attribute value should be cleared, as Position is

Observed Behavior

When trying to save, error "Cannot select a rack face without assigning a rack" was received, and Position attribute was reset to previous value.

[AliMickey]

+1, thanks for raising this and can confirm same behaviour on v4.3.7 (this isn't new behaviour, goes back a few major versions but I never bothered raising it).

[DanSheps]

Should be fixed with the introduction of the new method by #20387 (#20375). May need to edit the bulk edit buttons though, will investigate this in a bit.