Rigwright v0.1.28

What's Changed

Added

• Add independent CI-V profiles for IC-756PRO, IC-756PROII, and IC-756PROIII,
  including their documented addresses, legacy mode commands, tuning steps,
  frequency ranges, controls, and model-specific meter surfaces.
• Add searchable Markdown extractions of all three instruction manuals and
  record their source PDFs, page counts, extraction tool, and the IC-756PROII
  hardware-validation target.
• Add separate Yaesu FT-1000 and FT-1000D legacy CAT profiles under the
  profile-owned src/yaesu/ft1000/ package, including documented 8N2/4800
  serial settings, five-byte commands, status-update decoding, split, mode,
  frequency, and PTT support.
• Add the interactive probe_wizard example for serial-device selection,
  bounded read-only identification, explicit model override, and opt-in
  minimum-power PTT validation with de-key and RF-power restoration.
• Expand probe_wizard with a file-backed HAL diagnostic that records
  advertised controls, meters, optional surfaces, timings, PASS/FAIL/SKIP
  results, and driver error details; safe same-value write round-trips are
  available only through explicit --exercise-writes.
• Improve CI-V discovery by scanning documented model addresses and baud
  rates, retaining the detected endpoint, and rejecting responses that do not
  contain both a parsed frequency and mode.
• Make diagnostic optional-surface results mode-aware for the IC-7300, so
  documented Data-mode limitations and unimplemented HAL methods are reported
  as skips instead of misleading driver failures.

Deliberate limitations

• The profiles are framework support; physical IC-756PROII validation remains
  pending and no hardware-validation claim is made yet.
• FT-1000/FT-1000D support is framework-level pending physical validation;
  Digimode 4 is an external serial/level interface and is not modeled as a
  separate radio protocol.

Full Changelog: v0.1.27...v0.1.28