Skip to content

Supported Devices

rolotrealanis98 edited this page Sep 13, 2026 · 1 revision

Open Apollo supports Universal Audio Apollo Thunderbolt and USB interfaces. Thunderbolt models use a native Linux kernel driver. USB models use a pure-userspace stack (UAC 2.0 audio + patched snd-usb-audio — no kernel module required).


Thunderbolt devices

Model Device Type Playback Record Preamps HiZ Status
Apollo 8P (original) 0x0A 26 26 8 2 Needs Testing
Apollo Solo 0x27 3 2 1 0 Needs Testing
Arrow 0x28 3 2 1 0 Needs Testing
Apollo Twin X 0x23 8 8 2 2 Needs Testing
Apollo Twin X Gen 2 0x3A 8 8 2 2 Needs Testing
Apollo x4 0x1F 24 22 4 2 Partially Verified
Apollo x4 Gen 2 0x36 24 22 4 2 Needs Testing
Apollo x6 0x1E 24 22 4 2 Needs Testing
Apollo x6 Gen 2 0x35 24 22 4 2 Needs Testing
Apollo x8 0x22 26 26 4 2 Needs Testing
Apollo x8 Gen 2 0x37 26 26 4 2 Needs Testing
Apollo x8p 0x20 34 32 8 2 Partially Verified
Apollo x8p Gen 2 0x38 26 26 8 2 Needs Testing
Apollo x16 0x21 34 34 8 2 Needs Testing
Apollo x16 Gen 2 0x39 34 34 8 2 Needs Testing
Apollo x16D 0x2A 34 34 0 0 Needs Testing

USB devices

USB Apollo models use UAC 2.0 audio. No kernel module is required — the FX3 firmware is uploaded from userspace on each power-on, and snd-usb-audio (with a 4-patch out-of-tree build) handles audio streaming. See USB RE findings for protocol details.

Model VID PID (live) Playback Record Preamps HiZ Status
Apollo Solo USB 0x2B5A 0x000D 6 10 2 2 Verified
Apollo Twin USB 0x2B5A 0x0002 10 22 2 2 Needs Testing
Apollo Twin X USB 0x2B5A 0x000F — — 2 2 Needs Testing

Note

USB setup uses sudo bash scripts/install-usb.sh. See Installation for details, or USB RE findings for protocol details.


Column definitions

  • Playback: Number of playback (output) channels at 48 kHz
  • Record: Number of record (input) channels at 48 kHz
  • Preamps: Number of analog preamp inputs with gain/48V/PAD controls
  • HiZ: Number of preamp channels that support Hi-Z (instrument) input
  • Status: Whether the model has been tested on Linux with this driver

What "Verified" means

Thunderbolt (Apollo x4)

The Apollo x4 is the primary development and test device. On this model, the following features are confirmed working:

  • Full duplex audio with 4 analog inputs (Mic 1-4) and 6 analog outputs (Monitor L/R, Line Out 1-4) verified
  • The driver exposes all 24 playback / 22 record ALSA channels, but S/PDIF, ADAT, and virtual (DAW playback) channels are unverified and likely not working
  • All six sample rates (44.1, 48, 88.2, 96, 176.4, 192 kHz)
  • Preamp gain control (all 4 channels)
  • Preamp flags: 48V phantom power, PAD, low cut, phase invert, mic/line switching
  • Monitor volume, mute, dim, mono. The talkback switch toggles, but talkback audio routing is not implemented (see Experimental Features)
  • DSP mixer routing (analog buses only — digital bus routing untested)
  • ALSA integration with 50+ mixer controls

Thunderbolt (Apollo x8p)

Confirmed on Fedora 44 / kernel 7.1.4 by contributor @Skrypt:

  • Full duplex at 26 in / 26 out, 48 kHz — stable over a 60-second soak with zero xruns and no IOMMU faults under intel_iommu=on. This test predates the driver fix that raised the x8p to 34 playback / 32 record channels; the additional channels have not been verified on hardware
  • All 8 preamps exposed as independent ALSA capture controls (−144 to +65 dB), each with its own input select and per-channel 48V
  • Channel identity is 1:1 — physical input N maps to capture channel AUX(N-1)
  • Inputs 1–2 are front-panel Hi-Z; inputs 3–8 are rear combo jacks, mic/line only

Warning

Rear inputs 3–8 default to Mic. A ¼" instrument or line-level source on those jacks reads as silence until you switch the channel to Line:

amixer -c Apollo cset name='Line 3 Input Select' Line

A microphone works out of the box in the default Mic mode. Inputs 1–2 (front, Hi-Z) are unaffected.

Not yet verified on this model: sample rates other than 48 kHz (the driver advertises 48 kHz only), digital I/O, and clock selection. The x8p also has no routing config yet — ua_get_routing_config() returns NULL for device type 0x20, so channel order is whatever the FPGA defaults to. Tracked in issue #52.

USB (Apollo Solo USB)

The Apollo Solo USB is fully verified on Ubuntu Studio 24.04 / Intel Tiger Lake-H (confirmed by contributor @stoneiboyz-sys). Full duplex is working with no daemon required:

  • 6ch playback (S32_LE 48kHz) confirmed on Ubuntu Studio 24.04 (kernel 6.17, Intel) and CachyOS (kernel 6.19, AMD)
  • 10ch capture — confirmed working on Ubuntu Studio 24.04; one-shot usb-full-init.py (38 packets, includes DSP program load) then modprobe snd_usb_audio
  • PipeWire capture — mic input working; Discord voice calls and pw-record confirmed
  • PipeWire playback — browser audio, system audio, DAWs working
  • Hardware monitoring — mic → headphones simultaneous with active PipeWire streams
  • Preamp gain, 48V, monitor level/mute — working via vendor control 0x03 (seq counter fix applied)
  • No daemon required — EP6 drain daemon removed; one-shot init is stable

Known limitation: usb-full-init.py crashes at packet 28 on some firmware builds (IIR biquad SRAM address mismatch — observed on CachyOS/AMD with a different Cauldron build). Playback-only still works on those systems.

See USB RE findings for the full protocol details.


What "Needs Testing" means

These models are recognized by the driver and have correct channel count configurations, but have not been tested on actual hardware. They likely work — the Apollo product line shares a common architecture — but may need adjustments to routing tables or feature flags.


How to help

If you own an Apollo model marked "Needs Testing", your contribution would be extremely valuable. Even basic testing (does the driver load? does ALSA see the device? does audio play?) helps us mark models as verified.

See How to Contribute for details, or jump straight to the device capture guides:

You can also run the quick probe script on Linux:

sudo ./tools/contribute/device-probe.sh

This reads basic device information and outputs a report you can submit.

Clone this wiki locally