MaxProFrame 1.11.0

Improvements

• Reset IDs asks before clearing, with the number of IDs it will clear, and reports what it cleared: the count in the status bar and each piece with its old ID in the Report view. Undo (Ctrl+Z) restores them. A selection without IDs is left alone, with a message. Before, it cleared at once and showed nothing.
• BOM / Cut List: every cut angle tells the face of the profile it is seen on: 45.0 <80 on a 80x40 tube means the 45° run across the 80 mm faces; a compound cut gives both, 45.0 <80 + 10.0 <40. The angles are read on the finished piece, so a bevel, an End Miter, an Extend / Cut or a cutout give the same text, inside a Part too. CutAngle1 is the start of the profile (the Bevel A side) and CutAngle2 its end, also for a trimmed end, which always went to CutAngle2. An end that is not one flat cut (Notch) keeps its "@" / "P" marks.
• BOM / Cut List: a new Ends column shows how both ends sit: \_/ (trapezoid), /_/ (parallelogram) or |_/ (one end square).
• Cut List: identical pieces of one stock bar (same ID, length, angles and ends) take one row with their Quantity, instead of one row each (pieces without ID keep one row each).
• Cut List: a piece turned end for end shares the row of the same piece: the Cut List prints the larger angle first, in CutAngle1. The BOM keeps CutAngle1 at the start of the profile.
• BOM / Cut List: the column titles, section titles and legends follow the FreeCAD language, with a Spanish translation, and so does the Create BOM panel. The marks, IDs, lengths and angles are not translated.

Fixes

• BOM / Cut List: the legends list the marks that are printed. The Cut List legend explained "~" while the angles of a TrimmedProfile are printed with "@", and both legends listed "-", which was never printed.