Home Assistant Entities

Here is where you'll find information on all the exposed entities of the ESPrinkler system. NOTE: The information shown below is just for a single program, in HA they will be repeated for programs 2 and 3 respectively.

Controls

Enable Program 1	Enables the program scripts to run, master enable/disable switch for the program
Program 1 Start/Stop	Main switch for sprinkler component program. Starts/stops the program. On = Start/Running, Off = Stop/Not Running
Start Program 1	Button to start or resume the program, button version of the main switch
Pause Program 1	Button to pause the currently running program
Stop Program 1	Stops the program from running, button version of the main switch

Sensors

Currently Running Zone	Outputs what zone is currently running. If no zone is on, its state will be “none”. For zone 1, its state will be “Zone 1” and so forth for each of the 8 zones
Program 1 Current Zone Remaining Time	Time remaining of the currently running zone
Program 1 Next Watering Cycle	Day of the week and time of the next scheduled day. Formatted as “[Day of the week] at [hh:mm]”, for example “Wednesday at 04:00”
Program 1 Sprinkler State	Outputs the sprinkler component state: Idle, Starting, Active, Stopping, Bypass, Unknown”
Program 1 Total Watering Duration	Total time remaining of the program's cycle

Configuration

Program 1 Enable Schedule Start Time 1 - 4	Switch to enable/disable the respective start time for the program, make sure to set the respective start time if you enable the switch NOTE: This entity is duplicated for each respective start time
Program 1 Schedule Start Time 1 - 4	Time in format for each respective start time. Format is based on user settings in Home Assistant NOTE: This entity is duplicated for each respective start time
Program 1 Repeat Cycles	Number of times a program will repeat, defaults to 0 Minimum = 0 Maximum = 5 NOTE: This entity is duplicated for each respective start time
Program 1 Water Monday - Sunday	Switch to enable/disable the day of the week to enable watering for each respective day of the week Enabled = Water on that day of the week Disabled = Do not water on that day of the week NOTE: This entity is duplicated for each respective start time
Program 1 Zone 1 - 8 Enable	Switch to enable/disable zones 1 to 8 for the program Enabled = zone ON Disabled = zone OFF NOTE: This entity is duplicated for each respective zone
Program 1 Zone 1 - 8 Duration	Duration in minutes for zones 1 to 8, the program Minimum = 1min Maximum = 120min NOTE: This entity is duplicated for each respective zone
Restart Device	Reboots the ESP32
Firmware	Current ESPHome firmware. Usually disabled by default on Home Assistant

Diagnostic

Connection Status	Sensor for the state of connection to Home Assistant
ESPHome Firmware Version	ESPHome version the firmware was compiled against as a text sensor
esprinkler-retic-controller	Location of the device (network based)
Uptime	How long the system has been running in seconds
Uptime (from Web Server)	How long the system has been running, taken from the web server and usually disabled by default on Home Assistant
Wifi Signal dB	Wifi signal strength in dB
Wifi Signal Percent	Wifi signal strength in percent (%)