You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Install over USB on nRF52 boards. Updates, clean installs and restores no longer need the board's drive or the reset button. If USB fails, MeshKit offers the drive as before.
Convert between MeshCore and Meshtastic (nRF52 and ESP32), carrying the node's name and location across. Converting to MeshCore asks whether the board should become a companion, repeater or room server.
Node-name limits are shown as you type: MeshCore 31 bytes (23 when the node shares its location in adverts; repeaters and room servers are held to 23), Meshtastic 39 long / 4 short. A new "Share location in adverts" switch sets whether a companion advertises its location.
Backups are labelled with the firmware inside, there are manual Back up buttons for every kind, and Settings ▸ Backups can delete them all.
Works offline. Release lists and downloaded firmware are kept for 30 days.
Other MeshCore firmware. Add builds from other GitHub projects in Settings ▸ Firmware.
Automatic updates with Sparkle (Settings ▸ Updates).
Clearer install, convert and restore sheets, a bottom bar with the exact file and the Convert menu, and VoiceOver labels throughout.
Fixes for frozen windows when macOS asks about removable volumes, stale node names after renaming, and blank port and drive pickers.
Known limits
Not notarised: Control-click ▸ Open on first launch.
The wrong-board warning needs a board that reports a recognisable USB name.
MeshCore's 23-byte advertised-name limit is taken from its source and hasn't been observed on air.
Once, after a serial restore, a Wio Tracker L1 didn't answer until it was restarted. It didn't happen again in later runs on the L1 or a Heltec T096. If a board stays silent after an install, unplug it and plug it back in.