You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Works with MeshCore 1.18.0. Updating from 1.17.1 keeps a node's settings; installs, clean installs and Convert work on a Heltec V3 (companion, repeater and room server) and a Wio Tracker L1.
Converting to a repeater or room server now replaces the characters the firmware refuses in a name ([ ] \ : , ? *) with spaces, and the sheet says so. The repeater name field shows an error for them too.
⌘S applies your changes on the Configure screens, so you can edit and apply with the keyboard.
The repeater's firmware version no longer shows a stray first line right after the board boots.
AGC reset interval now allows 0 to 1020 seconds, which is what the firmware accepts.
Known limits
Not notarised: Control-click ▸ Open on first launch.
The wrong-board warning needs a board that reports a recognisable USB name.
MeshCore's 23-byte advertised-name limit is taken from its source and hasn't been observed on air.
Restoring an nRF52 backup over serial was tested on 1.17.1; on 1.18.0 only installs and clean installs were run.