Skip to content

Choose a tag to compare

@therealdreg therealdreg released this 10 Nov 00:38
· 1 commit to main since this release
image

Full speed and NKRO USB keyboards, keyboard formats kept across restarts, and flashing the ESP32-C2 and building from Linux.

New

  • USB full speed keyboards are captured, with the same firmware as low speed ones.
  • NKRO bitmaps, long key arrays, report IDs and non-boot reports on extra interfaces are logged: the RP2040 reads each keyboard's HID descriptors while the PC enumerates it, and keeps the formats it reads from them in flash across restarts.
  • USB capture starts about 0.1 s after a reset.
  • A Logitech Unifying receiver is logged on Linux too (tested on Ubuntu 26.04).
  • upload_firmware.sh flashes the ESP32-C2 from Linux, and make_release.py builds a whole release there (Ubuntu 26.04, flashing through a development board's CP2102N).
  • README: a table of tested keyboards that you can add your results to.

Fixed

  • A mistyped WiFi network or password falls back to the access point instead of locking you out.
  • OTA uploads no longer fail with room left on the flash, and an update that rolls back leaves both chips on the old firmware.
  • The RP2040 leaves the ESP32-C2's boot pins at normal-boot levels while it resets it.

Upgrading from v7

  • Over WiFi with the .pkg (done from v7 to a v9 test build on a PS/2 board; not tried on a USB board). The update wipes the settings: confirm it from the access point within 5 minutes. Download the keystroke log first.
  • USB: plug NKRO and report-ID keyboards in again once after the update.
photo_6021392202099003316_y