Repository navigation
MITM and Sniff
7h30th3r0n3 edited this page Jan 29, 2026
·
3 revisions
RaspyJack can launch an ARP-based MITM attack with traffic capture and save packets to a PCAP file.
- arp-scan (host discovery)
- arpspoof (ARP poisoning)
- tcpdump (packet capture)
- Select the active interface (eth0 or wlanX).
- Detect local network and choose /24 or /16 if needed.
- Scan hosts using
arp-scan. - Start ARP poisoning between gateway and hosts.
- Enable IP forwarding and capture traffic with
tcpdump.
- Tools installed by
install_raspyjack.sh. - Network with multiple hosts.
PCAP files are saved to:
loot/MITM/network_traffic_<timestamp>.pcap
-
Q: Why does it say “No hosts found”?
A: The interface may not be connected to a LAN with other devices, or ARP scan is blocked. -
Q: How do I open the PCAP?
A: Copy the file to a PC and open it in Wireshark. -
Q: “arp-scan: command not found”.
A: Install it withsudo apt install arp-scanor rerun the installer. -
Q: No traffic in the capture.
A: Ensure IP forwarding is enabled and victims are actually sending traffic. -
Q: “Device or resource busy” on interface.
A: Another tool is using the interface. Stop it or choose a different interface.
RaspyJack is for educational and authorized testing only. Use responsibly.
RaspyJack Wiki
Getting Started
Using RaspyJack
Payloads
Built-in Tools
Utilities
Reference
Radio & SDR
NFC & RFID
WebUI
Hardware