Repository navigation
Build Status
Bobby Bonestell edited this page Aug 1, 2026
·
7 revisions
BlueBuzzah v3 documentation is under active construction. Some pages describe hardware that has not yet been through a full build-and-verify pass. This page tracks exactly what's incomplete, so you know what to expect before you start.
Two callout states are used across the wiki to flag this:
Important
In design. The v3 enclosure has not been designed yet. You can build, wire, flash, and bench-test a complete pair of gloves, but you cannot yet mount them on a glove for daily wear. No substitute enclosure is recommended.
Note
Photos pending. These steps are complete in text; illustrations are not yet available.
| Page | What's missing |
|---|---|
| Part 7 Enclosure and Mounting | v3 enclosure has not been designed. No mounting solution exists yet for daily wear. |
| Page | What's missing |
|---|---|
| Part 5 Mounting Tactors in Glove Fingertips | Fingertip mounting, glove sizing, and thumb-specific geometry are described in text only; no illustrations yet. |
| Part 6 Wiring the Glove Harness | Harness routing, strain relief, and the canonical finger-to-port wiring are described in text only; no illustrations yet. |
Copyright © 2026 BlueBuzzah Partners. All rights reserved.
- Part 1 Ordering the PCB
- Part 2 Flashing and Smoke Testing the Bare Board
- Part 3 Building the Tactors
- Part 4 LRA Housing Assembly
- Part 5 Mounting Tactors in Glove Fingertips
- Part 6 Wiring the Glove Harness
- Part 7 Enclosure and Mounting
- Part 8 First Power On and Full Bench Test
- Part 9 Using the Gloves