Repository navigation
DecLAB 0.2.0: satellite, data tabs, squelch
Satellite, Digital voice data tabs, AM/FM squelch, NXDN voice from real repeaters.
New
- Satellite (M4): DVB-S, DVB-S2 and DVB-S2X as a plug-in, found blind. Transport streams go to the same services list, player and guide as DVB-T; GSE goes out as IP datagrams to a PCAP file.
- Digital voice data tabs: the right-hand box has Heard · Hex · LRRP · IP. Hex shows every data message (DMR packet data, TETRA SDS) in hex with ASCII beside it. LRRP is a table of location messages; click a position to copy it. IP lists the datagrams and takes one apart (IPv4/UDP headers with the checksum checked, payload in hex), with a PCAP recorder. DMR's header-compressed packets are rebuilt as whole datagrams.
- AM/FM squelch with three methods, each with its own threshold: Level (dBFS), SNR (estimated from the signal, independent of gain) and Noise (the classic FM noise squelch). It fades in and out over 5 ms, with no clicks.
--record-channel OUT.cf32ondeclab runrecords just the decoder's channel at its own rate (about 0.6 MB/s for voice, against 20 MB/s for the radio's stream), for long recordings of one channel.- Finer spectrum as you zoom in. Each VFO keeps its own decoder waterfalls.
Fixed
- NXDN voice was silent on real repeaters. Every voice frame was rejected by a wrong header-parity check (MMDVMHost's shortcut, which only covers the values it sends itself). Checked on 30 minutes of a real NXDN48 repeater: 10 calls, all at 0.00–0.15 % voice BER.
- NXDN no longer reports "control channel" or "unknown" messages decoded from silence after a repeater's beacon.
- DMR locks from any start. TETRA relocks after a drag.
- The command-line tool stopped printing the log after 300 lines.
Known limits
- The NXDN SACCH doesn't decode on that repeater yet (RAN not shown). Voice and call details come through regardless.
- NXDN trunking control channels (CAC) are not decoded.
- Satellite has been tested on simulated carriers only.
Pictures (from simulated signals)
Digital voice: every data message in hex with ASCII beside it.

LRRP location messages as a table.

IP datagrams, one taken apart, with the PCAP recorder.

Satellite: a DVB-S2X carrier, 8PSK 25/36, its transport stream and services.

The squelch picker in Settings (Level, SNR or Noise), here for NFM.

Download: DecLAB-0.2.0-windows-x64.zip has the two exes (no installer). Radios need the WinUSB driver (Zadig). The DVB video player needs an ffmpeg.exe beside the exes. TETRA speech is not included (ETSI code).