Repository navigation
HyprW 1.3.0
Install: download hyprw-1.3.0.zip, then in Blender Edit → Preferences → Get Extensions → Install from Disk (replaces 1.2.0). Requirements: Blender 5.2 or newer (tested on 5.3.0), Linux x86-64. Restart Blender after updating: the engine library is only loaded at start.
New
- Inflow turbulence (Inflow › Turbulence, default 10 %, and Eddies): the water leaving an inflow swirls like a real river instead of leaving as one smooth, rigid slab. Strength after measurements in open channels (Nezu 1977: 7–15 % of the mean speed for typical rivers); a divergence-free eddy field with a Kolmogorov spectrum (Kraichnan 1970), carried with the flow (Taylor 1938). Eddies sets the size of the largest swirls; 0 takes the inflow's thinnest side. Checked: 9.5–10.4 % fluctuation per direction at 10 %.
- The inflow still delivers the water it should: inside it the water keeps the mean velocity, and each particle gets its swirl as it leaves through the outlet. Measured without an outflow over 24 frames: +0.4 % water at 10 %, +7 % at 25 % (smaller time steps alone add about 1.7 %).
Changed
- Inflows are turbulent by default (10 %). New bakes of older scenes look rougher; set Turbulence to 0 % for the smooth inflow of 1.2.
- Turbulence needs Constrain Velocity (on by default); without it the setting is greyed out.
Tests: 292 checks, 0 failures.
