Skip to content

(3) Features.

Massimo 'Max' Mucci edited this page Jun 27, 2023 · 5 revisions

Standalone rotation

Standalone rotation of the RX/Single or TX antenna (or array) happens by tapping the CW or CCW buttons.
CW_CCW

Go to

Tapping the center of the RX or TX antenna image pops up a "go to" input screen to enter and initiate a rotation to a specified angle for the selected antenna.
GOTO

TX 2 RX

Pushing this button initiates a rotation of the TX antenna toward the same angle as the RX antenna.
TX2RX

Target

The TARGET button allows you to enter the GRID of the DX station.
Target
Once you have entered the GRID, the system calculates the Spatial Offset and the presumed Faraday rotation based on the position of the RX antenna. The presumed Faraday rotation is updated while you rotate the RX antenna, assuming you are aiming for the best signal.
Those values are shown on the main page.
Offset  Farady
Tap on OFFSET and the RX antenna will rotate to the Spatial Offset degrees.
Tap on FARADAY and the TX antenna will rotate to those degrees.

Info

Once the TARGET GRID has been entered, Moon info for both locations can be seen from the INFO page:
info
MOON_INFO_SM

Link TX and RX

This function is activated by pushing the LINKED button.
The TX antenna will rotate to the RX antenna angle and any further movement of the RX antenna will be followed by the TX antenna. The two antennas are synchronized.
Linked

Ptt link

And now, for the real fun.
ptt
Once this function is activated 1: the TX antenna will immediately rotate to the RX antenna angle.
While receiving
2: the TX antenna will follow any RX antenna movement.
Switching into transmitting
3: Both antennas will rotate to compensate for the presumed Faraday rotation.
Switching back to receiving
4: Both antennas will rotate back to the previous position.

Config and Calibration

The Config page is accessible through the CONFIG button.
conf
This page allows you to update your callsign and your grid, calibrate the potentiometers (full CW and full CCW), and see what features have been activated in the code.
CONFIG_SM

Clone this wiki locally