Incubator-arduino

🐣 Smart Egg Incubator using ESP32 + Blynk

This is an IoT-enabled Smart Egg Incubator system built with an ESP32 microcontroller, a DHT11 temperature and humidity sensor, a relay-controlled heating element, fan, buzzer, LCD display, and Blynk for real-time monitoring and control.

🔧 Features

• Real-time monitoring of temperature and humidity via Blynk mobile app
• Automatic control of heating element and fan based on temperature thresholds
• Visual alerts using LCD display
• Buzzer alert system for abnormal conditions
• Manual relay control from Blynk App

Components Used

• ESP32 Development Board
• DHT11 Temperature & Humidity Sensor
• Relay Module (for heating element)
• Fan
• Buzzer
• I2C 16x2 LCD Display
• Blynk IoT Mobile App

🔌 Pin Configuration

Component	ESP32 Pin
DHT11 Sensor	GPIO 4
Relay	GPIO 26
Fan	GPIO 27
Buzzer	GPIO 25
LCD (I2C)	0x27 (I2C Address)

📱 Blynk Setup

• Template ID: TMPL2hV6NYYnJ

• Template Name: Incubator

• Auth Token: Replace "UCtHxS5uELtKN7HkegxaMyc0V-KXFpZf4" with your actual Blynk token

• Virtual Pins:

  • V0: Temperature
  • V1: Humidity
  • V2: Manual relay control

🛠 How It Works

• Every 5 seconds, the ESP32 reads temperature and humidity values from the DHT11 sensor.

• The data is displayed on the LCD and sent to the Blynk app.

• If the temperature:

  • Exceeds 38°C → Fan turns ON, heater OFF.
  • Falls below 36°C → Fan turns OFF, heater ON.
  • Is between 36–38°C → Alert buzzer beeps intermittently.

• The relay can also be controlled manually via Blynk (V2).