Use Orca settings or Klipper for Ender Pro 3?

[mw4jet]

I have a Bambu A1 and an Ender Pro 3. I have been using Cura, sending prints to device via Klipper setup on Ubuntu server. I went through the calibration/setup for flow rate, retraction, pressure adv, etc, initially in Klipper, but I see Orca has all that as well. I have gotten it set up as an Ender 3 and provided IP address and can send prints but they are not good. Initially I used the Klipper in Orca selection but all it would do was heat the bed, no homing, no extruder warm up etc. I expect the start and end g-code was the problem but am unsure.

The A1 works good, so, how do you handle something like this? I really want to use 1 slicer and like the Bambu Studio so Orca is the best option.

[mw4jet]

So in thinking more on this, (I am learning big time) in Klipper I added the offset for the Sprite extruder with BL Touch, did calibrations according to the Klipper GIT pages. But I am seeing that Orca has those settings as well, won't that cause conflicts? I also have mainsail and moonraker set up with the Kiauh setup script. Should I start fresh with Klipper?