Repository navigation
PaNasMs 0.2.31
PaNasMs 0.2.31 adds configurable final-shutdown power cut-off on compatible Raspberry Pi 5 systems.
- Settings → General → Power control can enable an external active-high OFF input and select its BCM GPIO, with the physical header pin shown alongside. Fresh installations leave the feature disabled.
- Power is removed by the kernel only at the final orderly power-off stage. Restarting the NAS keeps power on. Enabling, disabling or changing the output takes effect after a restart; settings show the active pin and any pending change.
- Cooling, OLED and detected peripheral conflicts are rejected. The active and configured pins remain reserved while a restart is pending. Boot-file writes and stale settings updates are guarded.
- Includes all merged core and interface changes since 0.2.30. Installable modules retain independent versions.
The physical Pi 5 + Radxa Penta SATA HAT uses GPIO25 (physical pin 22), a 1 kΩ series resistor to Pololu OFF and a 10 kΩ OFF–GND pull-down. The external A–GND button only starts the NAS. Normal restart preserving power was verified remotely; the owner confirmed complete shutdown and subsequent button start. A button that requests shutdown through an optocoupler remains an unimplemented extension.
Validation: native ARM64 and AMD64 package builds, backend tests/vet/race checks, Python tests, frontend unit/build checks and power-settings browser interaction tests during development. Hardware support is Raspberry Pi 5-specific; this release does not claim a new clean-install acceptance cycle on every supported platform.
Update through Settings → System updates → Stable. The signed updater verifies artifacts and backs up installed packages/configuration. Restart after changing power-control settings; installing this release does not require an additional restart if the same configuration is already active.
Hardware wiring and setup: https://panasms.github.io/hardware/rpi_radxa_penta/#power-control