Repository navigation
B3 ORGAN 0.3
Three manuals, a new flash chip, finer reverb. What is new since 0.2:
Three manuals. Upper, lower and pedal, as in setBfree. Each has its own drawbars; the lower manual has its own vibrato on/off; the pedal has the 16' and 8' drawbars, no percussion and no vibrato. One scanner (vibrato / chorus) serves upper and lower, as in setBfree; the percussion and the pedal never go through it.
MIDI channels. Channel 1 plays the upper manual, 2 the lower one, 3 the pedal (USB and the TRS jack). The drawbar controllers 70 to 78 follow the channel (pedal: 70 = 16', 72 = 8').
Three screens (KNOB 1 switches): upper, lower, pedal. The manual of the screen shows its drawbars, the other two a line of digits. The chosen preset is on every screen. SELECT picks the drawbar, ALGORITHM sets it.
Screen 3 also shows the load of the audio block (µs, wheels sounding, peak) and a MIDI indicator: the channel and kind of the last message that came in (CH 2, ON, CC 64, PC 12) and a counter.
Keys: REC puts the FM-1's own keys on the upper, lower or pedal manual (shown as KEYS UPPER and so on on every screen). FX switches the vibrato of the screen's manual, LFO the Leslie, SEL the overdrive. EDIT and SAVE are left free.
Controls moved: the screen is on KNOB 1, KNOB 2 switches the vibrato / chorus V1, C1, V2, C2, V3, C3 (vibrato 1/2/3 and chorus 1/2/3), the overdrive amount (0 to 8) on KNOB 3, the reverb on KNOB 4, the overdrive on/off on SEL (it was EDIT).
Reverb in doubling steps on KNOB 4: 0, 1, 2, 4, 8, 16, 32, 64, 127 (fine at the bottom). CC 91 still sets any value.
New flash chip. Newer FM-1s carry a UC25HQ80 (JEDEC id 0xB36014) instead of the Puya P25Q80 (0x856014). The firmware and the update loader accept both now (as Dinghy 0.5): an older build saved to RAM only on the new chip, and its update loader did not know it. Tested on an FM-1 with the new chip: the firmware installs. Please say if your FM-1 has the new chip and it works.
Signal path changes that can be heard: the percussion is no longer modulated by the vibrato (it was in 0.2; setBfree keeps it dry), and the key compression counts the keys of all three manuals.
Measured, as in 0.2: with the same settings the overdrive behaves as in 0.2 (the level of every step against "overdrive off" within 0.3 dB); the Leslie (stop, slow, fast, ramps) agrees with a Raspberry Pi running setBfree in the modulation depth and the speeds.
Please note:
The saved settings have a new layout: the first start of 0.3 begins with the defaults (going back to 0.2 does the same).
A MIDI keyboard that sends CC 1, 64, 65 or 66 (modulation wheel, sustain, sostenuto) switches the Leslie, the overdrive or the percussion, as in setBfree. Screen 3 shows what arrives.
"Play in Browser" is still the upper manual only.
Open: a line at 4190 Hz (the 12th harmonic of F4) that is louder on the Raspberry Pi than here; not explained yet.
Install: download b3organ-0.3.fwsc and use the FM-1 Firmware Hub, or see the README. 0.2 stays available under Releases as a fallback. Please report what sounds different from setBfree.