Repository navigation
B3 Organ
A logo, an install page and two small fixes; the organ sounds as in 0.5. What is new since 0.5:
- A logo after switching on: a row of drawbars over the name. It comes back as a screen saver after a minute without a knob, a
button or a key. The first knob or button only brings back the upper manual's page (it changes nothing); a key plays at once. - The install shows its progress on the FM-1: the logo with a bar under it while it waits (UPDATE MODE), while it writes
(WRITING 57 %, DO NOT SWITCH OFF) and if it fails (UPDATE FAILED, INSTALL AGAIN). After 100 % the FM-1 restarts. - Install from the browser: r-jeb.github.io/setBfree-fm1 in Chrome or Edge, the FM-1 on USB,
with the four pages and every control explained. It also takes the FM-1 back to the official firmware. - The lower and pedal pages show the footage numbers under their drawbars again (16, 5 1/3, 8 ...); they were cut off on the FM-1.
- The pedal page no longer shows the load: page 4 (test values) has it, with the MIDI messages.
- A first start without saved settings has setBfree's drive 12 (it was 3, from the old character steps).
Your settings and your own programs 112 to 127 stay through the update.
Install: on the page above, or b3organ-0.5.1.fwsc with the FM-1 Firmware Hub or the README's other ways. 0.5 stays available under Releases.
Please report what sounds different from setBfree.