Repository navigation
The first release of ACSI2TNFS: a Raspberry Pi Pico 2 W on the ACSI port of an Atari ST,
STE, Mega ST, Mega STE or TT.
What it does
- Settings drive (C:) in the Pico's flash, with the configuration program
ACSITNFS.PRG, the STinG installerSTINGINS.TOSandNETCLOCK.PRG. - Network drives: folders on a TNFS server as hard disk partitions, readable and
writable. - SD card drives: folders on the micro SD card in the adapter, also without Wi-Fi.
With a card in, writes to the network drives are cached on it (about six times faster). - Internet with the STinG TCP/IP stack, installed with
STINGINS.TOS. - The clock set from the internet (NTP).
- Update check:
ACSITNFS.PRGtells you when a newer firmware is out.
Install
- Download
acsi2tnfs.uf2below. - Hold the Pico's BOOTSEL button while you plug it into a PC, and copy the file onto the
drive that appears. The Pico restarts and prepares its settings drive. - Connect the adapter to the Atari and follow Getting started in the
README.
Updating from an earlier build: copy the new file the same way. Your settings and your own
files on C: stay; the system files on C: are updated by themselves.
Hardware
For the boards v2 (DB19 on the board) and v2-cable (flat cable to a Lotharek
adapter, pass-through). See hardware/README.md.
Tested with
- ST with TOS 1.04 and the adapter's own driver, with AHDI, and with EmuTOS 1.1.1
- Mega STE with TOS 2.06 and HDDRIVER (adapter on ACSI id 1)
Good to know
- Mega STE and TT: set the adapter to the first free ACSI id (Mega STE: 1, TT: 0).
- Avoid Show Info on a large network or SD drive: it opens every folder and fills
the room of the drive. With the adapter's own driver, and with HDDRIVER after console
M, the drive starts afresh by itself; with AHDI and EmuTOS reset the Atari. See
Empty folders. - File names are 8.3, and every network or SD drive is 16 MB at a time.
- Not tested yet: the TT with AHDI in this release, an exFAT card, and the card detect
switch of the SD socket.