Skip to content

v0.1.6

Pre-release
Pre-release

Choose a tag to compare

@github-actions github-actions released this 05 Nov 07:20
· 16 commits to main since this release

STM32F103 PMIC firmware v0.1.6 (engineering candidate)

  • Left layout: FW_VER 0.1.6-left. Automatically enables PB3 EN and PA3 ICTRL after three valid ADC samples when the input is 16-32 V, CH224 reports available current, and no fault is latched. BMS/USART1 and PB4 are unused.
  • Right layout: FW_VER 0.1.2-right; application behavior is unchanged. The CI binary has a new embedded RT-Thread build timestamp.
  • Each layout archive contains boot.bin, boot.hex, ChargeBAT.bin, ChargeBAT.hex, and SHA256SUMS. Bootloader address: 0x08000000. Application address: 0x08001000. Select the matching board layout.

Validation: v0.1.6 built in CI. The same left-layout control logic in v0.1.5-left was flashed and tested on one STM32F103C8 board: 5 V Type-C kept EN low; 20 V PD set PB3 high and TIM2 CCR4 to 5040. The test had no battery pack connected. v0.1.6-left itself has not been flashed.

Not qualified for production charging. A battery pack with independent charge cutoff protection is required. Loaded charge current, charge termination, external EN voltage, temperature, and ADC calibration remain unverified.