Repository navigation
Troubleshooting and Diagnostics
-
Cannot connect to the charger
Wrong address, charger offline, or a firewall/VLAN between Home Assistant and the charger. Verify withping. -
The address is not a valid host name or IP address; an IPv6 address goes in brackets
The Host field holds something that is no address. Enter the IPv4 address or host name. -
Invalid password
The password is the Wattpilot.Solar app password, not your Wi-Fi or Fronius account password. -
The charger at this address has a different serial number
The address now belongs to another charger. Use Reconfigure on the right entry. -
This entry belongs to charger X, but the charger at this address reports serial Y
Setup refuses rather than move this entry's history onto another device. If the address was reused, point the entry at the right one with Reconfigure. If you replaced the charger, delete the entry and add the new one; the serial is the entry's identity, so the old history cannot follow. -
Charger X is already configured by another entry, or in Reconfigure This charger already has another entry
An entry carried over from the earlier integration found its charger set up a second time. Delete that other entry, then reload the carried-over one (or submit Reconfigure or the re-authentication again): only the carried-over entry keeps the earlier entity IDs and history. -
Repair notice: Another charger answers at this charger's address
Found while running: the integration stops connecting instead of showing the other charger's readings. Point the entry at the right address with Reconfigure; the notice goes away with the reload that follows. -
Repair notice: The charger refused the connection
The charger asks for a sign-in method this version does not know, usually after a firmware update. Look for an update of the integration; the notice goes away once the charger is connected again or the integration is reloaded. -
Repair notice: Some entities could not be migrated
An entity from the earlier integration could not take its new identifier because an entity with it already existed. Nothing was deleted: the old one keeps its history but shows as unavailable, the loaded one carries on. Delete the unavailable ones once their history no longer matters. -
Device … is not a loaded Wattpilot charger
An action got adevice_idthat is not a Wattpilot charger, or the entry is not loaded. Pick the charger's device, and reload the entry if needed. -
All entities unavailable
The charger is offline or the connection dropped. It reconnects by itself within five minutes of the charger being reachable again. Afterwattpilot.disconnect_chargerit stays disconnected untilwattpilot.reconnect_chargeror a reload. -
Cloud connections are not supported yet
An entry migrated from an older integration was configured for cloud. Reconfigure it with the local address. -
Some entities are missing
Firmware- or variant-gated, not reported by your charger, or disabled by default. See Entities and check the disabled entities on the device page. -
Phases in use shows 0
No phase is switched through to the car, the normal state while not charging.
Attach the entry's Download diagnostics output. It is redacted before it reaches you: serial number, host names, the device name the entry stores, passwords, cloud API tokens, MAC addresses, Wi-Fi SSIDs, ID-chip names, the log of neighbouring networks and free-text fields (such as a load group name, a Wi-Fi error message, the last cloud error, or a Wattpilot Flex's OCPP fallback card and tariff text) are dropped or replaced. MAC and IP addresses and the serial number are also replaced wherever they appear inside other text. A car profile other than the default shows only whether it is a known one; an unknown one shows only its length. Still look over the file before posting it.
The integration's own messages and Home Assistant's messages about setting up the entry show only the last two digits of the serial number, and the integration names an entity by its key. On an installation set up with 0.2.0 or earlier, entity IDs contain the serial number, and other parts of Home Assistant log entity IDs (recorder warnings, for example). Look over a log before posting it.