Migrating in KDE EndeavourOS

[Centaro0]

Hello, I have tried the manual migration by adding your repo to a fresh KDE EndeavourOS, but after a reboot, the boot up gets stuck after reaching the graphical target.

Here is what I did:

- sudo pacman-key --recv-keys 73580DE2EDDFA6D6
- sudo pacman-key --finger 73580DE2EDDFA6D6
- sudo pacman-key --lsign-key 73580DE2EDDFA6D6
- **Added "[xlibre]\Server = https://x11libre.net/repo/arch_based/x86_64 at the bottom of the repo list**
- sudo pacman -Sy
- pacman -S xlibre-xserver xlibre-input-libinput ###### and I accepted all of the replacements
- pacman -Q | grep '^xorg-server-\|^xf86' | cut -d' ' -f1 | sed 's/^xorg-server-/xlibre-xserver-/' | sed 's/^xf86-/xlibre-/' | xargs -ro pacman -Syy ###### but there was no stdin or stdout
- **I checked whether SDDM could be started with xlibre, but only X11 and Wayland were listed under Settings>SDDM>Behaviour**

I will continue troubleshooting later, but maybe someone has an idea of what step is missing?

[Centaro0]

I am trying to run startx with different stacks. I try to find the error codes in the Github page for the Xlibre xserver, but to no avail.

This is with the xlibre repo disabled.

    xlibre-input-libinput
    xlibre-xserver
    xlibre-xserver-common
    xlibre-xserver-devel

The above stack errors out with code 0x565

    xlibre-input-libinput
    xlibre-xserver-bootstrap
    xlibre-xserver-common

The above stack errors out with code 0x55c

    xlibre-input-libinput
    xlibre-xserver
    xlibre-xserver-common

The above stack errors out with code 0x560

The xlibre-input-libinput-bin stack fails to install

Now, with the Xlibre repo enabled

    xlibre-input-libinput
    xlibre-xserver
    xlibre-xserver-common

The above stack errored out with 0x55d

[Centaro0]

However, the error codes are not consistent. Every time I run the last stack, I get a different error code.

~/.local/share/xorg/Xorg.0.log will have better answers, but I am going to try to first reinstall the OS and give it a try following the AUR pinned comments.

[Centaro0]

Stock EndeavourOS only has xf86-input-libinput, xorg-server and xorg-server-common

Following the pinned comment on https://aur.archlinux.org/packages/xlibre-xserver#comment-1037485 did not work on a fresh EndeavourOS

Build and install xlibre-xserver-bootstrap
Build and install xlibre-input-libinput
Build and install xlibre-xserver and confirm pacman's request to remove xlibre-xserver-bootstap

Same point of failure and left me with

xlibre-input-libinput
xlibre-xserver
xlibre-xserver-common

[Centaro0]

If somebody wants ~/.local/share/xorg/Xorg.0.log from some of the stacks, then let me know and I will upload them here. All of them or a specific one.