S3 Problems

[storchalberto]

I am tring to use an seed studio S3 XIAO Board, using the last release of tasmota32s3.factory.bin, but it is impossible to connect the board to my wifi network based on a vodafone station router. i have changed a lot of parameters, but no result. the S3 works correctly in ap mode or connnected to a smartphone used as AP, but do not work with Vodafone Station. Anyone has seen this problem?

[storchalberto]

i am doing this test: i have compiled using benzino the developement version (but the standard version do the same). I download the factory version and start the device. i see that it start as ap, if i do the wifiscan 1 i see a lot of wifi network, but most important i see my network. these are the diagnostic.:
00:00:00.625 BRY: Berry initialized, RAM used 4055 bytes
00:00:00.639 Project tasmota - Tasmota Version 15.4.0.3(ESP32_S3_TEST)-3.3.8(2026-06-09T18:35:02)
00:00:01.669 HTP: Web server active on tasmota-C694CC-5324 with IP address 192.168.4.1
00:00:12.475 CMD: wifiscan 1
00:00:12.478 RSL: RESULT = {"WiFiScan":"Scanning"}
00:00:17.826 RSL: RESULT = {"WiFiScan":{"NET1":{"SSId":"MiaReteCasa","BSSId":"60:1B:52:65:B2:46","Channel":"13","Signal":"-55","RSSI":"90","Encryption":"WPA2/PSK"}}}
..... some other wifi networks.
Now i load only the ssid1 but not the password.
Both if i insert the correct ssid (MiaReteCasa) or an arbitrary ssid (pippo), the device restart and, at this point, the wifiscan 1 result:
00:00:10.813 RSL: RESULT = {"WiFiScan":"Scanning"}
00:00:13.311 RSL: RESULT = {"WiFiScan":"No networks found"}
So it seems that the setting of the board to connect to an AP, generate the malfunctioning of the WIFI stack., and do not depend from the router: it happens also if i set the ssid1 to an unexistent wifi network).
Any suggestion or other testings?

[storchalberto]

in addition. if i do the reset 1 command, the wifiscan 1 runs good and found the wifi networks.

[storchalberto]

i have used chatgpt to do a test. the suggestion to avoid strange loops of the sw tht locks the board, is to load all the wifi parameters in a baclog command (Backlog SSID1 NomeDellaTuaRete; Password1 LaTuaPasswordWifi; WifiConfig 4; Restart 1).
After this the board take a good connection and work correctly. cah someone investigate on this?