e1000e: Fix wrong comment related to link detection

Reading e1000e_check_for_copper_link() shows that get_link_status is set to
false after link has been detected. Therefore, it stays TRUE until then.

Signed-off-by: Benjamin Poirier <bpoirier@suse.com>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

Author: gobenji

drivers/net/ethernet/intel/e1000e/netdev.c

@@ -5074,7 +5074,7 @@ static bool e1000e_has_link(struct e1000_adapter *adapter)
 
 	/* get_link_status is set on LSC (link status) interrupt or
 	 * Rx sequence error interrupt.  get_link_status will stay
-	 * false until the check_for_link establishes link
+	 * true until the check_for_link establishes link
 	 * for copper adapters ONLY
 	 */
 	switch (hw->phy.media_type) {
@@ -5092,7 +5092,7 @@ static bool e1000e_has_link(struct e1000_adapter *adapter)
 		break;
 	case e1000_media_type_internal_serdes:
 		ret_val = hw->mac.ops.check_for_link(hw);
-		link_active = adapter->hw.mac.serdes_has_link;
+		link_active = hw->mac.serdes_has_link;
 		break;
 	default:
 	case e1000_media_type_unknown: