Skip to content

MHO900 test build 11: mho-acq-1, second try (development build)

Pre-release
Pre-release

Choose a tag to compare

@dekajoule dekajoule released this 22 Nov 16:37
· 87 commits to main since this release

Development build for testing on an MHO900. Not a release. mho-acq-1, second try: it fixes why
mho-dev-10 stopped at once on every unit. Not yet
verified on hardware.

  • mho-start read the snapshot's line select sysref_reset54 0 wrongly and stopped. It reads every line now, and
    of those lines it drives the twelve front-end select lines only (never the PMIC's or the panel's lines that the
    snapshot also records).
  • The run's control words now start from known values instead of their read-back from the snapshot, which carries
    state bits (seen in the MHO934's and an MHO98's snapshots). With them, the first acquisition would likely have
    failed next.

Your snapshot from mho-check.py version 9 stays valid: no new snapshot needed. Install this build as you did dev-10,
then run oos-mho-live again. The steps are in issue #4.

File What
oos-mho900-dev-11.img the OOS image, for the install on a second card (boot/card-install.py, then boot/switch.py oos)
oos-mho900-dev-11.oosupd the same image as a signed package, for the install over ADB (oos-update gel-install)
oos-update the install tool of this build, for the scope (aarch64)
MHO900_OOS_Install.GEL the stick install. Not known whether the stock MHO900 update accepts it. Use the ADB or card route
SHA256SUMS checksums

Built from tag mho-dev-11 with kernel/build-base.sh (the kernel of mho-dev-10) and OOS_BOARD=mho boot/build-dev-image.sh, Linux 6.12.115. Sources: this tag, and the third-party sources of v0.1.14.