Skip to content

Hush 1.1.0

Choose a tag to compare

@disco-trooper disco-trooper released this 03 Nov 13:15
· 3 commits to main since this release

Recording off, Remote Play on

Hush 1.0 stopped the console's continuous recording, but Remote Play goes through
the same encoder, so with Hush loaded a stream never got a picture
(#3). 1.1.0 adds a mode that
keeps both.

hold_s

hold_s=30

The console builds the recording encoder once, early in a game, and does not
retry when that fails. With hold_s=N, Hush patches sceVencStartEncode when a
game process appears, holds the patch for N seconds, then restores every slot.
Recording stays off for that whole game session — Save Recent Gameplay still
answers “Gameplay isn't being recorded” — and the encoder is free for Remote
Play afterwards.

Measured on 13.60 with Kingdom Come: Deliverance II: armed within a second of the
game starting, four slots redirected, four restored 30 s later, no clip saved,
and a stream of the running game had its picture.

hold_s=0 is the default and keeps the 1.0 behaviour: the patch stays for as
long as Hush runs.

Know before you use it

  • Don't connect during the window. A stream started in the first N seconds
    of a game gets no picture and leaves the console on “still finishing the last
    Remote Play session” until it is restarted.
  • Load Hush before the game. A game that is already running is skipped; it
    is covered from its next start.
  • If a title still records, its recorder started after the window. Raise
    hold_s (60, then 120); a new value applies from the next game start.
  • Only one title on one firmware has been measured. Reports from other games are
    welcome.

Also in this release

  • In hold mode config.ini is re-read every second, so enabled=0 restores and
    exits within a second.
  • On start, slots that still point at the stub — left by a run killed mid-window
    — are found and restored even without state.txt.
  • A failed restore is logged and retried; a replaced capture daemon is detected.
  • rescan_s defaults to 60 instead of 300, so slots that appear after a game
    start are picked up sooner.

Full list in CHANGELOG.md.

Install

sha256sum -c SHA256SUMS      # Linux
shasum -a 256 -c SHA256SUMS  # macOS

Replace hush.elf in Payload Manager. Existing config.ini files keep working;
add hold_s=30 if you use Remote Play, then reboot or reload Hush.

Build

7ce9356eaf28d3fa2e3cfcd6b93300e5321c385d087409912ae3b29e6855a8d3  hush.elf

Reproducible with the same toolchain (-Wl,--build-id=none): two clean builds of
this tag gave this exact binary. Built with Homebrew clang/LLD 23.1.4.