Home
Welcome to the i3 Berlin wiki!
These pages contain the full assembly manual to build and adjust your i3 Berlin through the following chapters:
Introduction About the history of this design and the power of open hardware.
Assembly of the Y-Unit The lower unit which holds the print platform.
Assembly of the XZ-Unit The vertical part that holds the extruder.
Wiring All the wires and where to put them, and you will join the two units.
Calibration See if everything works correctly and adjust it perfectly.
Printing How to use your printer and some tips to get started.
##i3 Berlin
1 Introduction
1.1: History
1.2: Tools and Parts
1.3: Preparing the Casings
2 Assembly of the Y-Unit
2.1: Rods and Power Supply
2.2: Front- and Back- Plate
2.3: Mounting Y-Carriage and Belt
3 Assembly of the XZ-Unit
3.1: Mounting the X-Axis
3.2: Mounting the Z-Axis
3.3: Mounting the Timing Belt
3.4: Assembling the Extruder
4 Wiring
4.1: Wiring the Power Supply
4.2: Wiring the Z-Unit
4.3: Wiring the Y-Unit
4.4: Wiring the X-Axis
4.5: Gluing the Endstop Magnets
4.6: Uploading Firmware
4.7: Wiring the Extruder
4.8: Mounting the Heatbed
5 Calibration
5.1: Testing Functionality
5.2: Calibrating the Y Axis
5.3: Calibrating the X Axis
5.4: Calibrating the Print Platform
6 Printing
6.1: Filament Holder
6.2: Cura
6.3: Kisslicer
6.4: Dual Printing