Repository navigation
Satellite Bridge 1.0.7 - AO-7 tracking repair
Pre-releaseVersion 1.0.7 build 11 fixes two faults seen while tracking AO-7 through RUMlogNG 6.6.1.
When AO-7 requests 2 m RX and 70 cm TX, the bridge now exchanges Main/Sub before tuning if TX occupies the requested RX band. Both bands verify before frequency setters; recalled TX power is held within 5% during transition. MacDoppler's 80% default follows only after its target frequency/mode verifies.
Continuous tracking keeps control of VFO selection across updates and restores the original panel view when leaving tracking or closing. Readouts use current AX elements. Frequency-only updates reuse the verified RX filter; mode/band changes or a reported mismatch reapply its rule.
131 local tests passed. A controlled real-radio replay verified automatic QO-100/AO-7 transitions and 60 consecutive pairs, with CW RX filter 2 and 80% during tracking, then QO-100 restoration at 4%. The installed app also passed three labeled validation packets and CW restoration after Accessibility renewal. These are panel/control checks, not an over-the-air contact or RF measurement. At the tested 19200 baud, control/readback averages about four seconds per pair; the newest pending report is retained.
RUMlogNG remains the sole physical CAT owner. TX CTCSS, receiver profiles, QO-100 manual tuning, virtual split and the 5% converter ceiling are retained. The app never keys PTT.
The README and supplied guide include the current build 11 screenshot. Intel macOS; Python/Tk bundled. Ad-hoc signed, not Developer ID signed or notarized. Replacing an existing executable may require renewing its Accessibility entry. Existing saved pairs and RUMlogNG macros are preserved.