Skip to content

Controlled Experiments

amarjeet-iiitd edited this page Jul 11, 2013 · 5 revisions

Multisensor

  • Try to correlate AC/Cooler power with the temperature in the room (check with Milan on similar things he has done)

FunF

  • Turn on Bluetooth/WiFi-hotspot on your phone and bring it closer to each phone. Check if the bluetooth/WiFi scans from Funf also say that you are in vicinity.
  • Collect some WiFi scan data from your laptop (check with Shailja/Sneihil for some appropriate utility) for different rooms. We will then compare the data from these scans with the data collected by Funf.
  • Note down different times when different appliances are on in a room to correlate with the audio data from the phone - run fan at different speeds, turn on AC (both with compressor on and compressor off), turn on TV etc.
  • Try putting the phone in the bathroom for a couple of days and note down the water use activities - will correlate the water consumption with the audio profile in the room (will be better if you can turn on motor during these times so that some of the water consumption comes from direct line meter which has better resolution).

CT

  • Since now you have a load map - have some times when all the loads on a CT are ensured to be off. note down these times and then compare with the CT readings. Turn on some loads one at a time and again note down these times to look at corresponding CT readings.

Water Meter

  • Try running motor briefly for a while when there is no water in the main pipe (dont run it for too long since it may harm the motor) and see if just the air flow also gives you the pulse.
  • When there is no water in the main line, try turning on some of the taps (sometimes it causes air flow and may lead to some pulse generation even when there is no water flow).

Laptop Data collection

Network Statistics

  • Take off the network and bring it back on yourself (manually) in 30 minutes interval for 3-4 times and look at what the logs say. The same thing then can be searched through the logs for regular down times.

jPlug

  • Check for AC power consumption for different temperature settings for AC
  • Check for Refrigerator power consumption for different temperature settings (internal)
  • Check for power consumption of washing machine for different settings it provides
  • For the geyser look at how much is it leakage power (i.e. after it is completely hot how much does in consume in the next 1-2 hours).

Current Cost

  • Try putting Current Cost on all the major appliances for some time and in parallel collect data from jPlug. This way we can compare Current Cost with jPlug for different appliances.

Clone this wiki locally