Repository navigation
v5.8
Whats new
Upgraded to wdsp v2.11 and added an NR5 NNR noise reduction option.
How to use NR5
- Turn it on from the main window: click the NR button repeatedly. It cycles: Off → NR1 → NR2 → NR3 → NR4 → NR5 → Off. For the second receiver, use the RX2 NR button the same way. You can also pick NR5 from the main DSP menu.
- Adjust it in Setup: open Setup → DSP tab → NR5 tab. There are separate RX1 and RX2 sections with controls for the model, mask floor, maximum gain, smoothing, and timing. Each section has a Defaults button to reset just that receiver.
- Remote control: NR5 is also accepted through the existing CAT (ZZNE/ZZNF) and TCI noise-reduction commands.
What each control does
- Model (0ΓÇô3): chooses which built-in neural network to use. Model 1 is the default larger general-purpose model, model 0 is a smaller general model, and models 2 and 3 are alternative models trained with more context (useful for weaker or CW-style signals). If one model sounds wrong for the noise you have, try another.
- Mask floor (dB): the lowest gain the noise reducer is allowed to apply. More negative values cut noise harder; values closer to 0 are gentler. Default is -25 dB.
- Max gain (dB): the most the processor may boost a signal above the noise estimate. Higher values can recover weaker audio but may also amplify artifacts; lower values are safer. Default is 12 dB.
- Alpha: shapes how aggressively low-level signals below the knee are treated. 1 is neutral, higher values suppress low-level content more, and lower values sound gentler and more natural. Default is 1.
- Alpha knee (dB): sets where that alpha shaping begins. A higher value applies it only to very low signals; a lower value spreads it over a wider range. Default is 10 dB.
- Tau (s): how quickly the noise estimate adapts. Longer values track steady noise more smoothly; shorter values follow changing noise faster. Default is 2 s.
- Smooth attack (ms): how fast the noise reduction opens up when a signal appears. 0 is instant; higher values are smoother but slower. Default is 0.
- Smooth release (ms): how fast it closes back down after a signal stops. 0 is instant; higher values reduce pumping but leave a longer tail. Default is 0.
- Output audio in both I and Q: Unchecked by default. Unchecked keeps normal audio in I with Q set to zero, Checked puts audio in both I and Q and is mainly for special routing/testing.
- Defaults: resets all NR5 controls for that receiver back to the values above.
Installer
-
.msi- the SDR-VST3 product. It requires the .NET 10 Desktop
Runtime (x64) to be installed on the machine. The installer checks
for it and tells you where to get it if it is missing:
https://dotnet.microsoft.com/download/dotnet/10.0If you already have an older SDR-VST3 installed, installing over it
upgrades in place.