Repository navigation
Dell Latitude 7455 (Snapdragon X Elite X1E-80-100) - working desktop on Omarchy 4.5, what it took #19382
Replies: 6 comments 2 replies
Update: the webcam works with a device-tree overlay, no kernel changesThe colour camera (OmniVision OV02E10) now streams on stock The wiring is from Linaro's arm64-laptops tree (
|
Update: colour tuning, a virtual webcam for Qt apps, and the indicator LEDFollow-up to the webcam overlay above, same machine and kernel ( Apps that list V4L2 devices don't see the cameraPipeWire lists "Built-in Front Camera", but Monologue (Qt Multimedia's A v4l2loopback device fed from PipeWire works: The DKMS module built against # ~/.config/systemd/user/camera-relay.service
[Unit]
Description=Relay the built-in camera to the virtual webcam (/dev/video42)
After=pipewire.service wireplumber.service
[Service]
ExecStart=/usr/bin/gst-launch-1.0 -q pipewiresrc target-object=libcamera_input._base_soc_0_cci_ac16000_i2c-bus_1_camera_10 ! video/x-raw,width=1920,height=1080 ! videoconvert ! video/x-raw,format=YUY2 ! v4l2sink device=/dev/video42 sync=false
Restart=on-failure
RestartSec=2Reading ColourWith Under warm indoor lighting they left a yellow-green cast, as described there. Measured on a white ceiling and grey walls, green was 6-9 % high and blue low. Scaling the matrix rows (R x1.04, G x0.90, B x1.10) brought walls and window frames back to neutral in my room. This is fitted by eye and by patch averages to one room under warm lamps, not a calibration, and I have not checked it in daylight.
|
Note on the IR camera: what Dell's driver pack containsFor anyone who wants to pick up the IR camera on this board. I have not attempted it; this is only what is in the Latitude 7455 Windows 11 Driver Pack (
The sensor-module blobs should hold the I2C address, lane assignment and power sequence for the HM1092, in the binary format #12441 ran into. Since the OV02E10 wiring is now known for this board (overlay above), the front-sensor blob could serve as a known-answer sample for decoding the aux one. What is missing on the Linux side: an HM1092 sensor driver, the board wiring (CCI bus and address, CSIPHY, reset, clock, supplies), and a description of the emitter. None of the device trees I checked (stable, edge, mainline, Linaro's arm64-laptops tree) describe the IR camera on the Dell boards. |
|
Thanks for writing this up. There's a hardware test for Omarchy now, and I'd like a run from your laptop on the Latitude 7455's page: https://arewearmyet.com/models/dell-latitude-7455
If you move to the edge channel later (kernel 7.3-73 today), a second run gives me something to compare. |
Update: camera tuning, the black level is what made it look washed outSame machine, now on edge ( Black level. With no Setting the black level explicitly to 64 on the sensor's 10-bit scale ( Colour matrix. With the black level fixed, I compared these on the same scene:
The factory matrices' rows each sum to 1, so blending them with the identity keeps greys grey. The R x1.04 / G x0.90 / B x1.10 scaling from my earlier comment isn't needed once the black level is right.
|
|
A packaged version of the relay you built, for the same Snapdragon camera path (CAMSS, libcamera software ISP, V4L2-only apps like Monologue), is in omacom/omarchy-pkgs#3244 for the Surface Laptop 7. I tested it on the 13.8" only, not on a Dell, and the sensor there is an OV02C10, not your OV02E10.
Drafted with Claude Fable 5.2 via Claude Code; the tests ran on my own laptop. |
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
Results as of 18 November 2026, from a fresh install with Windows wiped.
This is a Latitude 7455 with the X1E-80-100, 16 GB RAM, the 2560x1600 touch panel, BIOS 2.9.0. I couldn't find anyone who had written this model up for Omarchy, and arewearmyet.com shows 0 of 30 checks, so here is what happened. The sibling Inspiron 14 Plus 7441 is covered in #12441; shared Snapdragon X notes are in #11823.
Setup
OMARCHY_202611aarch64 ISO, version 2026.11.05qcom-firmware-extracthad no partition to readWhat happened out of the box
The installer ran fine. The installed system then looked dead: a dark screen after the boot menu. Three separate things were going on.
Ctrl+Alt+F2(withFnon this keyboard) gives a login prompt. The kernel log had:/lib/firmware/qcom/x1e80100/dell/latitude-7455/held one symlink and nothing else./etc/modprobe.d/qualcomm-adsp-nofw.conf(blacklist qcom_q6v5_pas) because the firmware was missing.Fixes
GPU (gets you a desktop)
The XPS 13 9345's GPU zap file, which linux-firmware already installs, is accepted by the Latitude 7455:
After that Hyprland comes up on the internal panel.
Audio, battery, video decode
The XPS 13 files do not work for the ADSP. With them copied in, the CDSP starts but the ADSP fails:
The model's own files are in Dell's Latitude 7455 Windows 11 Driver Pack (
Latitude 7455-Win11-A01-W394W.CAB, from Dell's support site). It is a plain cabinet file;bsdtarextracts it. The files are under:Win11/arm64/chipset/Y9XHN_A00-00/qcsubsys_ext_adsp8380/qcadsp8380.mbn,adsp_dtbs.elf,adspr.jsn,adsps.jsn,adspua.jsn,battmgr.jsnWin11/arm64/chipset/Y9XHN_A00-00/qcnspmcdm_ext_cdsp8380/qccdsp8380.mbn,cdsp_dtbs.elf,cdspr.jsnWin11/arm64/video/KY3G8_A00-00/qcdx8380/qcvss8380.mbnWin11/arm64/video/KY3G8_A00-00/qcdx8380/qcdxkmsuc8380.mbn(not tested here; the XPS copy was already working)Copy them into
/lib/firmware/qcom/x1e80100/dell/latitude-7455/, then remove the blacklist and reboot:Starting the ADSP in a running session leaves the sound card on the "off" profile in PipeWire; after a clean boot it comes up with the speakers as the default output.
Status after the fixes
dp_aux_backlightreportsmax_brightness1023 here, unlike the 0 reported for the 7441 and for this model on Ubuntu. Keys not testedqcom-iris-decoder/-encoderenumerate onceqcvss8380.mbnis installed; actual decode not testedlinux-omarchy-dtbs7.3-48). IR camera not workinghid-over-i2c 29BD:9081)Suggestions
qcom-firmware-extractcould accept a Dell driver-pack CAB as a source for machines where Windows is already gone.cci@ac16000), would be the next step for the webcam.Happy to test images or patches on this machine.
All reactions