Repository navigation
circuitRF 1.9.3
Filter Designer
Contributed by @aissus in #77. Thank you!
- New Filter Designer (Tools ▸ Filter Designer…). Enter the filter you want (response, band, order, ripple) and circuitRF lists every way it can build it: a lumped ladder, coupled resonators such as a hairpin, or coupled lines. Each one shows its response next to the ideal one.
- The ideal response uses your board's real unloaded Q, so the insertion loss you see is the one you'll get.
- Run Planar EM checks the drawn filter with the EM solver, and Polish corrects it from that result.
- Place puts the filter in your schematic as an ordinary part you can tune, optimise and lay out.
- Also on the command line:
circuitrf filter.
EMerge Update for 3D EM
- circuitRF now installs and uses EMerge 3.0.10. It solves a lot faster - about 2x.
- New Iterative option for EMerge. It uses about a third less memory for the same answer, but is usually a little slower than a direct solve.
- If you already have EMerge, update it: Settings ▸ Solvers ▸ Update to EMerge 3.0.10…. EMerge older than 3.0.8 no longer supported in circuitRF, and circuitRF tells you how to update.
- Some results move slightly with the new EMerge: circuitRF tests indicate that wave-port S-parameters are now more reciprocal and thin metal sheets now agree better with Palace.
- When a run won't fit in memory, circuitRF now offers Use the Iterative Solver instead of stopping. The memory estimate is also more accurate, so you'll see fewer needless warnings.
- Wave ports now pick the line's own mode. Before, ground metal on the top layer at the port could make it pick the wrong mode and give badly wrong S-parameters. For a well-matched port on grounded coplanar line, put a via under each top ground at the port.
- Square waveguides can now use a two-mode wave port.
Phased arrays
- The Phased Array tool now works with the mmWave Array Link example and shows the receiving array's pattern too (#75).
- The tool now opens harmonic-balance benches that sit inside a sweep, such as a PA swept over drive power.
Propagation Channel improvements
These came from @msasdk's questions in #75. Thank you!
- Propagation Channel: the + button adds any of its parameters by name.
cdf()now works across several sweep axes, giving one curve for each point of the others.
Fixed
- Fixed: Manage Libraries ▸ Remove no longer crashes circuitRF (#76, reported by @johanssonK. Thank you!).
- Fixed: EIRP and total radiated power from a harmonic-balance array run are now at the real drive power. They were reported as if the array were driven at 0 dBm.
- Fixed: the Parameter dialog no longer grows taller than the screen.
- A parametric sweep keeps going when one point is outside a model's range. That point is left blank and the rest run.
- The variable editor keeps each variable's unit when you apply the text view. (Part of #75 fix.)