Skip to content

Draftwright 0.5.0-rc10

Pre-release
Pre-release

Choose a tag to compare

@pzfreo pzfreo released this 06 Oct 21:46
16d7ce4

Draftwright 0.5.0-rc10

This is a prerelease for evaluation. Inspect generated drawings, lint, and requirement reports before using them for manufacturing.

Since rc9

  • Avoid duplicate planned bore-axis locations when authored AP242 PMI already specifies the same physical location. #2201
  • Preserve supported AP242 basic dimensions as boxed ink; unsupported or conflicting cases are reported rather than silently drawn as ordinary dimensions. #2200
  • Let imported PMI dimensions use space held by a provisional section that will not render. On the Specify fixture, two of three previously missing authored 40 locations now place; one remains reported. #2203
  • Recover A3 2:1 for the supplied PMI-enabled spindle after an optional section drops, and interleave generated datum-to-step dimensions with imported PMI in measured-span order. #2205

Known limitations

  • The Specify plate still has a reported authored PMI no-room drop; #2192 remains open. The spindle fixture still has two recognized but missing step-length requirements. This RC does not claim either drawing is complete.
  • Other limitations listed in rc9 remain unless addressed above.

Install after publication with python -m pip install --pre draftwright==0.5.0rc10.

Full changes since rc9