Skip to content

Draftwright 0.5.0-rc6

Pre-release
Pre-release

Choose a tag to compare

@pzfreo pzfreo released this 04 Oct 13:25
462d91f

Draftwright 0.5.0-rc6

This is a prerelease for evaluation. Inspect generated drawings and their lint and requirement reports before using them for manufacturing.

Since rc5

  • CTC-01 pitch and PMI: A single pitch gap is labelled with its value, without a 1× prefix. Source-specific AP242 diameter requirements stay attached to their physical pattern members, while the generic pattern callout retains count, THRU state, pitch, and location without repeating those sizes. #2173 · #2174
  • GRM-03 manufacturing PMI: The STEP-stated knurl maximum diameter appears in both the manufacturing row and its linked leader. Source-scoped edge condition and face finish requirements appear with their STEP identity and are independently checked against the final drawing. #2179 · #2180
  • GRM-03 A4 layout: Automatic layout can use A4 at 5:1 to keep all 17 required annotations, including the side-hole callout. Datum symbols stay local to their source faces when possible; the C0.5 label is kept clear of the narrow shaft; detail captions are separated from nearby callouts. Forced A4 at 2:1 reports remaining cramped conditions. #2181
  • Validation: CTC-01 slow tests now follow the member-specific PMI identity and its generated Sheet script. #2178

Known limitations

  • The CTC-01 automatic PMI arrangements remain incomplete; inspect their reported missing requirements.
  • A forced A3 1:2 permissive GRM-03 document sheet can still omit datum A/B symbols when their source-normal corridors cannot fit. It retains the authored datum explanation in GENERAL NOTES and reports pmi_dropped.
  • The dense CTC04 specimen yields an invalid drawing: the 150° angular annotation conflicts with two hole callouts, and some required outcomes cannot fit. #2167
  • Dense CTC02 and CTC04 builds take longer than in rc3. #2166
  • A STEP file that declares an older Part21 encoding level but contains raw UTF-8 text can prevent the Part21 parser from extracting available PMI. The drawing report marks this as an error. #1958

Install after publication with python -m pip install --pre draftwright==0.5.0rc6.

Full changes since rc5