Skip to content

Draftwright 0.5.0-rc8

Pre-release
Pre-release

Choose a tag to compare

@pzfreo pzfreo released this 05 Oct 10:16
555c75e

Draftwright 0.5.0-rc8

This is a prerelease for evaluation. Inspect generated drawings and their lint and requirement reports before using them for manufacturing.

Since rc7

  • Offset planar PMI witnesses: An AP242 dimension between parallel face groups is measured along their proved common normal, so sideways-offset face centres no longer make a valid size look diagonal. Unproved support and mismatched values still fail closed. #2186
  • Authored dimension precedence: AP242 sizes and locations cover matching planned dimensions instead of being printed twice. On a turned profile, an authored baseline determines the scheme and uncovered shoulders are dimensioned from the same reference end. Bore callouts retain imported nominal precision or fit wording where the feature owner is proved. Drawing.dimension_sources() exposes the source of each placed measurement. Ambiguous matches remain visible to lint. #2187

Known limitations

  • A Document acquired with PMI annotations can still carry source AP242 tolerance overrides into a member whose PMI mode is off or report. #2188
  • The reporter's private AP242 STEP specimens for these two fixes were unavailable for direct replay. The regressions use synthetic OCC geometry, authored IR, both planar extraction paths, finished drawings, and generated Sheet round trips.
  • The CTC-01 automatic PMI arrangements remain incomplete; inspect their reported missing requirements.
  • A forced A3 1:2 permissive GRM-03 document sheet can still omit datum A/B symbols when their source-normal corridors cannot fit. It retains the authored datum explanation in GENERAL NOTES and reports pmi_dropped.
  • The dense CTC04 specimen yields an invalid drawing: the 150° angular annotation conflicts with two hole callouts, and some required outcomes cannot fit. #2167
  • Dense CTC02 and CTC04 builds take longer than in rc3. #2166
  • A STEP file that declares an older Part21 encoding level but contains raw UTF-8 text can prevent the Part21 parser from extracting available PMI. The drawing report marks this as an error. #1958

Install after publication with python -m pip install --pre draftwright==0.5.0rc8.

Full changes since rc7