Repository navigation
Draftwright 0.5.0-rc9
Pre-release
Pre-release
Draftwright 0.5.0-rc9
This is a prerelease for evaluation. Inspect generated drawings and their lint and requirement reports before using them for manufacturing.
Since rc8
- Complete strip annotation ink must stay within the sheet. An authored PMI dimension whose witness lines would leave the page is dropped with a diagnostic instead of being drawn off-sheet; this also lets other authored dimensions use the freed space. #2191
- The authored pocket-wall location
75 +0.1/0is extracted and drawn from a proved face witness. Bore-axis location60is extracted from a plane-to-axis witness, and cylindrical position frames target the true face-on view. These changes improve source fidelity but do not guarantee every PMI item fits. #2193, #2194 - Automatic PMI layout skips scale trials whose bare principal projections cannot fit on the page and avoids a measured repack caused solely by a late table. There is no fixed runtime cap or relaxed completeness check. The #2192 Specify plate completed in 94.5 seconds in the measured run, versus the roughly ten minutes previously observed, and still reports four source-PMI drops. #2197
Known limitations
- The #2192 Specify plate remains incomplete: some authored PMI still cannot be placed and is reported, despite the corrected extraction and faster layout. #2192
- Other limitations listed in rc8 have not been claimed resolved by this release.
Install after publication with python -m pip install --pre draftwright==0.5.0rc9.