Repository navigation
Membrane Control 0.1.25 - Valve commands and sensor setup
Pre-release
Pre-release
Membrane Control 0.1.25 incorporates the tested Bluetooth reconnection fix and improves live sensor estimates and manual valve commands.
Developed for Dr. Onita Basu's lab at Carleton University.
- Install MembraneControl-Setup-0.1.25-windows-x64.exe. If the board is still on the v0.1.24 Bluetooth image, use Flash normal controller (Bluetooth) over wired USB with the valve and pump loads isolated, then use the existing outgoing Bluetooth port.
- The Dashboard shows a labeled live estimate for each sensor in range. With two measured points in Sensor setup, it uses your fit within the captured range for that connection. Commissioned readings continue to drive the run and its protection.
- The serial queue sends the opening Bluetooth heartbeat before a subsequently queued manual valve command. Use the normal Dashboard toggles to hold a valve open and Stop valves to release all valves. A lost controller link still releases them.
Bluetooth controller instructions · Sensor setup instructions