Repository navigation
v0.1.3
Pre-release
Pre-release
A pre-release, still not tested on hardware.
- New: an image file on this computer can be written to an SD card or USB
drive ("Use an image file on this computer" on the Board and Image steps,
or drop the file on the window): .img, .img.xz, .img.gz, .img.bz2. A file
with the name of an image in the Roxora releases is checked against that
release's SHA-256 and written without a download. Any other file is
written as a custom image: the app says that no release vouches for it,
reads it once to take the SHA-256 of its decompressed data, and compares
the drive with that after writing. Zip archives are not taken, and the
app does not yet open when an image file is double-clicked. - Maskrom, SPI NOR flash: a file that cannot be a bootloader is refused
when it is chosen instead of after the board is connected: one larger
than the board's SPI flash (16 MiB on the ROCK 4D; 32 MiB where the size
is not known), and a whole disk image (the name of a release image, or a
partition table that reaches past the flash). The message points to the
release's SPI bootloader and to writing the image to an SD card. - macOS: SD cards and USB drives are now written through Apple's
authopen,
as Raspberry Pi Imager and Armbian Imager do, instead of a writer running
as root. With 0.1.2 a card on a Mac could keep its old contents from 17 MiB
on (the read-back check reported it), and opening the drive could fail with
"EPERM: operation not permitted". macOS asks for the password once per
write, for that one drive; Full Disk Access is not needed. The data goes to
the raw disk in whole 1 MiB pieces and is read back through the same open
drive. Tested in CI against a RAM disk, not yet on a real card. - macOS: the DMG no longer contains the etcher-sdk writer, only the small
helperroxora-imager-rawdisk.