Repository navigation
ZeroSend 0.1.1 (pre-release, untested on hardware)
Pre-releaseZeroSend now follows the network when Wi-Fi comes and goes.
Warning
Pre-release, not yet tested on a real CardputerZero. Built and tested in the
device-configuration build (fbdev, evdev, arm64 Debian trixie), like 0.1.0. See
Status.
Fixed
LocalSend's core binds device discovery to the network interfaces that exist when it starts, and
never again. In 0.1.0 that meant:
- Opened before Wi-Fi connected: no IP shown, and nearby devices could not find ZeroSend
even once Wi-Fi was up, until the app was restarted. - Wi-Fi dropped: nothing changed on screen. It still said Ready with the old address.
- Wi-Fi came back: discovery most likely stayed deaf until a restart.
0.1.1 re-reads the network every 3 seconds. It shows No network instead of Ready while
there is none, and restarts discovery by itself when the network changes.
Also new: a transfer whose other device walks away mid-way is flagged Stalled after 15
seconds without data, instead of a progress bar frozen on its last speed. Press Esc to cancel it.
Install
From a computer on the same network as the CardputerZero:
scp ZeroSend_0.1.1_m5stack1_arm64.deb pi@cardputerzero.local:/tmp/
ssh pi@cardputerzero.local 'sudo apt install /tmp/ZeroSend_0.1.1_m5stack1_arm64.deb &&
systemctl --user restart APPLaunch.service'It upgrades 0.1.0 in place. Pairings and settings are kept. Or over USB: set the USB switch to the
left, enable ADB in Settings → Developer, adb push the file to /tmp/, run the same
apt install in adb shell, and reboot.
Package: zerosend 0.1.1-m5stack1, arm64, for the CardputerZero's Debian trixie image.
Check the download against ZeroSend_0.1.1_m5stack1_arm64.deb.sha256.