Configuring 0.99 Actions and Reports

<<< Back to Configuring Version 0.99 Main Page

Commands and Reports

These $configs invoke reports and functions

Command	Description	Notes
{sr:n}	get Status Report	SR also sets status report format in JSON mode
{qr:n}	get Queue Report
{qf:_}	flush_planner_queue	Used with '!' feedhold for jogging, probes and other sequences. Usage: {qf:1}
{md:n}	Disable motors	Unpower all motors
{me:_}	Energize motors	Energize all motors with timeout in seconds
{test:_}	Invoke self tests	$test=n for test number; $test returns help screen in text mode
{defa:1}	reset to DEFAults	Reset to compiled default settings
[{flash:1}]	Enter_FLASH_loader	WILL ERASE AND REFLASH BOARD. BE CAREFUL WITH THIS
^x	Reset g2core	cntl+x restarts g2core same as hardware rest button
[{help:_}]	Show help screen	Show system help screen; $h also works

Note: Status report parameters is settable in JSON only - see JSON mode for details

Commands

These commands cause various actions, and are not technically "settings".

$SR - Status Report

Returns a status report or set the contents of a status report (JSON only). Identical to ? command. See Status Reports for details.

$QR - Queue Report

Manually request a queue report. See $QV for details.

$QF - Queue Flush

Removes all Gcode blocks remaining in the planner queue. This is useful to clear the buffer after a feedhold to create homing, jogging, probes and other cycles.

$MD - Motor De-energize

Unpower all motors. See Power Management

$ME - Motor Energize

Energizes all non-disabled motors. Motors will time out according to their power management a mode and timeout value. See Power Management

$TEST - Run Self Test

Execute $test to get a listing of available tests. Run $test=N, where N is the test number.

$DEFA - Reset default profile settings

g2core comes with a set of defaults pre-programmed to a specific machine profile. The default profile is set for a relatively slow screw machine such as the Zen Toolworks 7x12. Other default profiles are settable at compile time by including the right settings_XXXXXX.h file. If you are having trouble with your settings and want to revert to the default settings enter: $defa=1

WARNING This will revert all settings to defaults. Do a screencap of the $$ dump if you want to refer back to the current settings