Repository navigation
What's new
- Flash programmer. With a SOIC-8 clip on the camera's flash, the unit speaks flashrom's
serprog protocol on port 8888 (flashrom 1.4.0 or later; IPv4 only, until flashrom has IPv6). - Firmware updates over the web. Upload a release's
-app.binin the status page's
Firmware section, or withcurl. A new firmware that is not back on the network within
five minutes rolls back by itself. - Wi-Fi TX power on the status page, 2 to 20 dBm.
- BOOTSEL, a second boot pin (GPIO6) for boards that bring out the SoC's boot select:
pulled low or driven high, as set. - One pinout for every S2 and S3 board, all on GPIO1 to 9: DevKitC-style boards, the
XIAO ESP32S3, the S3 Super Mini, the Waveshare ESP32-S3-Zero and the S2 Mini. - The
esp32s3-psramimage is gone:esp32s3runs on every S3 module.
Upgrading from 0.1.x
- Rewire. Camera UART TX and RX are on GPIO1 and GPIO2, power on GPIO4, the boot pin on
GPIO9, BOOTSEL on GPIO6, and the clip's CS, CLK and DO on GPIO5, GPIO7 and GPIO8. See
Wiring in the README. - Write the first-install image once, over USB. 0.2.0 has two firmware slots, so the
partition table changed. The first-install image erases the Wi-Fi settings; set them up
again in the portal. Every update after that can go over the web.
Per chip, thingino-backpack-<chip>.bin is a first install: write it at 0x0. It holds
the bootloader, the partition table and the app, and erases the saved Wi-Fi, so the
unit starts in its setup portal. thingino-backpack-<chip>-app.bin is an update that
keeps the Wi-Fi settings: upload it in the status page's Firmware section, or write it
at 0x20000 over USB after erasing the OTA state.
esptool.py --chip esp32s3 write_flash 0x0 thingino-backpack-esp32s3.bin
curl -X POST --data-binary @thingino-backpack-esp32s3-app.bin http://<host>.local/api/ota
Units on 0.1.x have the single-slot layout and take the first-install image once.
esp32s3 runs on every ESP32-S3 module, PSRAM or not. The esp32s2 and esp32p4
images are untested on hardware; see the README.
Full Changelog: v0.1.1...v0.2.0