PI-Flow PC🖥

As per many requests from my reddit post about my Raspberry pi pc case i made by reconstruction my old Pi-satelite shell iv decieded to reopen the old files and remodel it into a fully fledged PC case for the Raspberry pi 3b-4

List of parts required!

• Any old laptop fan (preferably HP L51102-001 laptop fan)
• Raspberry pi 3 or 4
• 6 x 6mm SPST Tactile Switch
• 3D Printed casing
• 4 neodymium magnets
• adhesive
• Jumper cables

Pinnout diagram for the fan and the button

• wire 2 female dupont cables by soldering them onto the ends of the switch and connect to gpio 3 and ground
• Wire the black and red wire respectivly on to the female dupon connectors and wire on (5V and ground or 3V and ground) fan speed may vary according to given voltage
• pwm wires are not needed so can be desoldered to your liking

Pinnout diagram:

3D Printed case!

Main Frame!

The case is designed Compactly sized to fit snugly around your components.this case also maximizes active ventilation and airflow with its well ventilated design

Subframe and cover!

this frame is to be glued on top the main frame with magnets to be installed on the given holes

Cover:

with the choice of 3 diffrent cover plates you can print any one to your liking

Acrlyc transparent sheet is required for the blank frame

magnets to be installed on the given holes

The case is also uploaded opensource in this page where you can download and modify your case to your liking!

Code for the power button:

git clone https://github.com/Howchoo/pi-power-button.git

./pi-power-button/script/install

Final Build!

(also to be noted the photos provided of the actuall build are of the prototype and the actuall build post print will yeild better results!)