Pi-Phone π(concept)

A raspberry pi based linux handheld touch device (for the pi 3/4)

List of parts required!

• 4.3 inch 800*480 LCD display
• Raspberry pi 3 or 4
• 6mm Mini Momentary pushbutton
• 3D Printed casing
• 3.7v 5000mah Lithium Polymer Battery
• Type-C 3.7V/4.2V Charger Module(female)
• Type C Connector with data(female)
• Pi-8Mp Camera module
• adhesive

Procedure:

• Start by stipping down the Pi's Ethernet port and usb hubs replacing the usb hubs whith type C Ports
• install the battery and camera module into the 3D Case
• Solder the Charger Module onto the battery and solder wires onto the raspberry pi's pre existing power port. Rewire the USB connections from the pi over to the Type C data port as well as the audio port!
• align and install the stripped down Pi ontop of the battery (apply insulation tape below and above the Pi before instalation)
• install the ports onto the case *Finish off by closing off the whole enclosure by connecting the ribbon cable of the camera module and display port onto the Pi!

Wiring diagram:

3D Printed case!

Main Enclosure!

Final Build!