Installation Checklist

Jump to bottom Edit New page

Clark Van Oyen edited this page May 2, 2015 · 11 revisions

What You Need for Installing

Bring extra sensors and an extra control box if travelling far.

Everything from the [Servicing Checklist](Servicing Checklist)
It is preferred the vessel powers the box using a 12V source, but if this isn’t readily available, you may need 110V AC/DC adapter.
EM hard drive key if applicable
Two hard drives with caddies
Keyboard
Monitor with vga and power cable
Linux boot drive
GPS aerial
Pressure sensor, with sensor cable
RFID scanner, with sensor cable
CCTV camera with BNC connection, coax cable, power cable

When Installing An EM System, Remember To:

Connect EM power (12V direct or AC adapter to 110V)
Identify and connect peripheral cables (GPS, PSI, cameras, RFID) as applicable
Install blank hard drive.
Power on the EM box.
Configure cameras to our tested settings.
Ensure all signals green in UI.
Operate hydraulics to test PSI response.
Plugin Battery Leads
Confirm psi trigger delay
Copy a data sample to USB
Note HDD and Control box serial numbers. # m9
Set home port geometry, and verify video recording pauses at port.
Configure a fake home port to test video recording.
Copy video samples and send to the team.
Configure the vessel name and VRN in /etc/vms.conf
Set vessel timezone. Ensure time is being set correctly by GPS.
Identify the best location for the three cameras and mount them to the vessel
Discuss the best placement for measuring strips with fisherman
Affix measuring strips
Fill in vessel information on VMP (attached)
Check the expected files are captured on the data drive.
Take photographs of:
The vessel
Installed control box
Installed monitor with screen shot
Installed hydraulic pressure sensor
Installed secondary fishing activity sensor (if applicable)
Installed GPS
Camera 1 location
Screen shot of camera 1 view
Camera 2 location
Screen shot of camera 2 view
Camera 3 location
Screen shot of camera 3 view