Breaking changes in dev/next pre-release

[FredrikM97]

Hi everyone! In the upcoming release I am moving the integration domain from surepetcare -> surepcha.

This will break most integrations but is required to avoid conflict with the core integration.

Due to the change there will be issues with the manifest. However this is fixed in HACS but not yet released.

They suggest two approaches:

Until a new release is cut, you need to apply manually, or set the "Get HACS" add-on to track dev.

I suggest to use the get hacs addon.

Follow guide at:
https://www.hacs.xyz/docs/use/download/download/#to-download-hacs

After installing the add-on don't forget to restart home assistant

Sorry for the inconvenience.

[Daneish]

In case others have this same issue, I found I had to remove the old configuration of Sure Petcare 1.4.9 and restart before I could configure version 2+. The full steps I followed:

• Install the Get HACS Add-on
• On the configuration tab set to the Development channel
• Start Add-on
• Check the Logs tab then restart when it finished downloading
• Update to Sure Petcare 2+
• Restart [You could likely skip this restart]
• Here is where I found Sure Petcare integration wouldn’t load due to a version conflict, so deleted the Sure Petcare configuration that was setup under 1.4.9
• Restart
• Setup Sure Petcare integration again - successfully.

Lastly just wanted to say thank you for your awesome work, I’m loving the extra functionality and stability of this integration!