Skip to content

Sourcing Parts

IceChes edited this page Mar 29, 2023 · 1 revision

The BOM

The BOM is simple to follow. Build a base Foundation using said BOM. Select items from the 3 tiers. The green option is the recommended one. Build a list of items and then purchase all of them.

There are optional items at the bottom of the BOM.

Finding Parts

Parts not in the BOM or in a supported mod BOM are not officially supported, so if your printer has a problem and you submit an issue, I may or may not help you.

Notes About Certain BOM Items

Mainboard

The Robin E3 is an evil little piece of electric witchcraft that at every step will fight you. It is the "cheap" mainboard option on the BOM.

Okay that might be an exaggeration but it's pretty bad.

First, run ls /dev/serial/by-path/* on the host device's console. It is very important that you run this command and not the typical ls /dev/serial/by-id/*. In your printer.cfg, replace the serial: /dev/serial/by-id/xxxxxxxxxxxxxx with your output from ls /dev/serial/by-path/*. The next two things have to do with flashing Klipper to the mainboard. First, you need an SD card of 256MB. If you don't have one, open a partition manager and wipe a larger card. Then, make a new 256MB FAT32 partition on the card. Do not make any other partitions. The next thing is to not flash Klipper, but a special version of the Klipper BIN from Makerbase that you can find here. The file must be named Robin_E3.bin. Insert your card and power cycle the board to flash it, and then remove the card.

Please avoid using this board.

SCS8UU Bearings

The cheap bearing options in the BOM might have too low of a preload for the average user. Pack them with excess grease or don't use them at all.

Steppers

The LDO motors option is completely unnecessary for this build. They are listed anyways for people that want to go very very fast.

Clone this wiki locally