M Prime One assembly guide

Jump to bottom Edit New page

Diego Trapero edited this page Jul 12, 2016 · 15 revisions

Z motor subassembly

Step 1. Motor

Bolt the motor to the Z motor holder printed part using 4 M3x10 (short) bolts.

Step 1

Step 2. Electronics holder

Bolt the electronic board holders to the X motor holder using 4 M3x20 (long) bolts.

Step 2

X motor subassembly

Step 1. Linear bearings

Attach 4 LM8UU linear bearings to the X motor holder printed part using 8 zip ties.

Step 1

Step 2. Belt bearings

Assemble the bearings that will guide the X axis timing belt.

First, place the M3x20 screws from the lower side of the X motor holder.
Then, place two M3 washers, two 623ZZ ball bearings, one M3 washer and one M3 nut in each bolt. Tighten the nut to secure the bearings.

Step 2.1

Step 2.2

Step 3. Bolt motor

Bolt the motor to the printed part using 4 M3x10 bolts. Attach the belt pulley to the motor shaft using the 2 setscrews. One of the setscrews should be tightened against the shaft flat surface so the pulley won’t move.

Step 3

Step 4. Endstop

Attach the endstop to its holder using two M3x20 bolts and two M3 nuts.

Step 4

YZ carriage subassembly

Step 1. Linear bearings

Attach 4 LM8UU linear bearings to the X motor holder printed part using 8 zip ties.

Step 1

Step 2. Belt bearings

Assemble the bearings that will guide the X axis timing belt.

First, place the M3x20 screws from the lower side of the X motor holder.
Then, place two M3 washers, two 623ZZ ball bearings, one M3 washer and one M3 nut in each bolt. Tighten the nut to secure the bearings.

Step 2.1

Step 2.2

Step 3. Y linear bearings

Step 3

Step 4. Motor and belt pulleys

Step 4

Step 5. Endstop

Step 6

`ia_1`- Main structure

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

`sa_printer_head`- Printer head subassembly

Step 1

Step 2

`ia_2`- Y axis

Step 1

Step 2

Step 3

Step 4.1

Step 4.2

Step 4.3

Step 4.4

`ia_3`- X axis

Step 1

Step 2

Step 3

Step 4.1

Step 4.2

Step 4.3

Step 5

`sa_ptsone`- PTSone extruder subassembly

Step 1

Step 2

Step 3

Step 4

`ia_4`- Attaching the extruder to the printer

Step 1